Finally I applied a good coat of Breakfree CLP. Rinsed the barrel with brake parts cleaner to remove excelīrushed once more with the brass brush and gun oil and Took a brass brush with gun oil and brushed in and around Of the barrel just in front of the step, where the stock and Previously mentioned there was a deep pit on the left side The front and rear barrel bands, butt plate, trigger The barrel to squeeze a little more accuracy out of it. My restoration plan included the following: I had no plan to “sporterize” this rifle. Really just wanted a good looking shooter in close to original condition. Than the standard 98K Mausers, so I couldn’t use many of the receiver Internet told me that the Yugoslavian Mausers had a slightly shorter action Words not add any accessories or improvements that it didn’t originally come I wanted to keep the rifle as close to original as possible in other Haven’t seen anything that can’t be fixed. The top of the stock and the hand guard, soaked the stock, and sat against the The safety of the rifle, but at some point water seeped into the gap between The left side of the barrel just past the step was a deep pit with lots of Trigger guard itself looked almost brand new with very little wear, rust or Seriously buggered from someone using a standard hardware store tapered blade The trigger guard, butt-stock, and rear sling swivel mount screws were Pitted and rusted with virtually no finish left. It along with some cheap, surplus, corrosive ammo.Īfter purchasing the rifle I completely disassembled it to see justįront and rear barrel bands, magazine floor plate and butt plate were somewhat Went through an arsenal rebuild, but based on my friend’s recommendation, I purchased The numbers didn’t match on the parts indicating it The bore looked in pretty good shape, the action wasīutter-smooth, and the stock had no major faults. If he didn’t already have four other Mausers.
Yugoslavian model 24 Mauser that he swore he would purchase
At a recent gun show a friend pointed out a Me very much, and in fact I only owned one that I obtained To be truthful bolt-action rifles never appealed to Again, this article is for entertainment purposesĪnd firearms are the trademark/service mark or registered trademarkĭuring a 3-gun match my local gun club ran a side match for Warning: Disassembling and tinkering with your firearm mayĬlaim no responsibility for use or misuse of this article. Special tools and cannot/should not be performed without Some procedures described in this article require Just a shooting enthusiast and hobbyist, as well as aĪrticle explains work that I performed to my guns without
#YUGO MAUSER 24 47 STOCKS PROFESSIONAL#
Please note that I am not a professional gunsmith, These loads, or use or misuse of this article. Mentioned in this article are my loads for my guns and haveīeen carefully worked up using established guidelines andĪuthor assumes no responsibility or liability for use of Please defer all firearms work to a qualified Disclaimer: This article is for entertainment only and is not toīe used in lieu of a qualified gunsmith.
0 kommentar(er)
